lacss.blogg.se

Zyxel usg flex
Zyxel usg flex













USG FLEX does not reboot when switching to cloud mode.Wait for ZTP to switch USG FLEX to cloud mode Paste the ZTP URL on Internet browser of PC/laptop or click on the "Allow Nebula to Manage My Device" link from the email. Scroll down through the email sent to you by Nebela to find the content below:Ĭonnect PC or laptop under LAN1 (192.168.1.0/24) port of USG FLEX You can reset the device to factory settings by running the "nf" configuration file or pressing the physical reset button on the gateway for 15 seconds. Since the device mode is being changed from standalone to cloud mode, it will need to be reset to factory settings. If the USG FLEX has been used in standalone mode please make sure to save a copy of the "nf" file to a safe place (computer or cloud drive service). Below are instructions on how to setup the USG FLEX using one of the two available activation methods. The email sent from Nebula will contain a *.json configuration file and a URL. There are two ways to configure the USG FLEX to link up with Nebula CC. Subject – “Register your Zyxel USG FLEX gateway_USG FLEX 100” Search Registration Email from your inbox Register USG FLEX in your Nebula organization This process must be done on site, never remotely. This will only work on USG FLEX appliances running 5.00 firmware or later.

zyxel usg flex

This article will go over the configuration setup to connect the USG FLEX with Nebula CC.















Zyxel usg flex